Paul H
Fearless OOS Poser
I forgot to measure while I was in the garage... Would a road crank fit on a mtb?so you have patience and hope - a little charity would go a long way......
I forgot to measure while I was in the garage... Would a road crank fit on a mtb?so you have patience and hope - a little charity would go a long way......
Until I die... Or someone buys it lolI must have fallen behind with this...what is that wheel for?
never mind, talon front wheel...are you still spending money on that thing?
Until I die... Or someone buys it lol
Well, the fork may have been worth something before you turned it into a spray can job alibaba special...Until I die... Or someone buys it lol
Clear onlyWait your only going clear?
Clear only
Reg sandpaper.Are you wet sanding you need to go much higher in grit
you're going to spray over that or are you doing that after clear? you'll need to clean of that off if you're going to sprayReg sandpaper.
I'm actually going to polish with meguiars 105 and then 405 to finish.
Sand... 105 and 205.you're going to spray over that or are you doing that after clear? you'll need to clean of that off if you're going to spray
Maybe you should paint your next rodeo black...Actually looks better in person... ok... maybe not...
View attachment 122363
WhyMaybe you should paint your next rodeo black...
Yep... you're right. No matter how much I sanded... I couldn't get the weaves to show and I didn't want to go too deep and eat into the resin.Because clear only works if you have a clean weave showing, that just looks messy, with the sanding not being flat and showing high and lows. I mean, the carbon is not exposed so that's ok.
Did you use a sanding block? That would help.Yep... you're right. No matter how much I sanded... I couldn't get the weaves to show and I didn't want to go too deep and eat into the resin.
But I kinda like that dirty glossy look. Looks f'ed up but its shinny. Maybe I just have some weird taste. lol