GSTim
Formerly M3Tim
Just the low key Shelby wave.
Car-spotting thread
- Thread starter UtahJoe
- Start date
rick81721
Lothar
gave him a headlight flash - he waved back. Followed a 911 turbo S into Lambertville but he didn't cross the bridge.
outstanding warrant in pa.
So I got the mustang mostly back on track after the hydraulic throwout bearing seal failed. Tilton sent me a new one....getting it set up on this car is an absolute ass pain tho....I need a spacer to move the trans back 1/4", so trying to get and measurements from the TOB to the face of the trans is useless until you put the trans in and compress the spacer. Even the face of this trans isnt all that good. At the end of the day, the only proper way I could do it was to install the trans and measure the gap with a feeler guage and go from there. That meant I had to take the trans in and out a number of times, which is really fun
it was a pain, but .125 gap +/- .025 on the nose
Windshield is in, rear glass should be done this week...headliner had to be fixed first. Fenders are going on tomorrow.
Put the new wheels on it the other day
god am I happy to be done with uni-lug wheels, fuck them with all the fucks
it was a pain, but .125 gap +/- .025 on the nose
Windshield is in, rear glass should be done this week...headliner had to be fixed first. Fenders are going on tomorrow.
Put the new wheels on it the other day
god am I happy to be done with uni-lug wheels, fuck them with all the fucks
Thats a vacuum pump for the PB....with the cam in this car, the brakes pedal would vary in level of terrifying before this pump. what a difference!
So I checked the wear mark on the input shaft there there should still be plenty of engagement...seemed to work fine when I tested it out, as in, the transmission didnt leap out of the car. Long term with this set up? going to have to find out I guess. but nothing else seemed to be affected much by the spacer, trans mount still line up, driveshaft had plenty of slack.
Steve Vai
Endurance Guy: Tolerates most of us.
IDK, it's a Camaro thing. I'm not sure if I like it or not.
jklett
Well-Known Member
Steve Vai
Endurance Guy: Tolerates most of us.
I like it more than I don't. Maybe 60/40. And you can't see shit out of the back window of a Camaro so you might as well block it all off!! 😂😂
knobbyhead
Next off the Island.
Anyone looking for more power for their mopar?
barnfinds.com
1,000 Horsepower Crate Engine! 426 Mopar Hellephant
The term "a piece of automotive history" can be thrown around indiscriminately sometimes, but in the case of this crate engine, it is true. You are looking at a 1000 horsepower, 426 cubic inch, "Hellephant" crate engine from Mopar! Debuting at SEMA 2018, the all-aluminum block and heads are...
barnfinds.com
THATmanMANNY
Well-Known Member
Turned off Blvd at next light :/
