THATmanMANNY
Well-Known Member
Probably the biggest bike wrenching fail and I build a lot of my bikes.
Thought it was just stuck a little like norm and just need some taps to get it in. Knocked the bearing out. It was lined up. Looked at it again. The spindle side near the end of the non drivr side definitely has an end that wont pass through the bearing/cup.
My BB size is 73mm
I did buy a gxp crankset. At least the box says so.
Thought it was just stuck a little like norm and just need some taps to get it in. Knocked the bearing out. It was lined up. Looked at it again. The spindle side near the end of the non drivr side definitely has an end that wont pass through the bearing/cup.
My BB size is 73mm
I did buy a gxp crankset. At least the box says so.
Last edited: