The bike has a 92mm x 41mm bb shell in the frame (BB92) but it came with Race Face Cinch 30mm cranks (not 24mm cranks typically used with a BB92). I want to keep the cranks for now. So I ended up getting the Hope PF4130 which looks identical to the Enduro and Wheels Manufacturing version and very similar to the Praxxis. The bearings press directly into the frame with no internal sleeve or cups. Apparently this allows larger, more durable bearings to be used than the original Race Face BB92. A threaded version is not available in the 41x30 configuration. If I get 24mm cranks I could go that route but then my cost would go way up as I would have to buy new cranks.
My question came from the fact that I have never installed a press fit BB before and when doing research I came across several recommendations for the proper way to install one including pressed in dry, with grease, with green loctite, with teflon pipe dope, and with anti-seize. So that pretty much made it clear as mud to determine the actual correct way to install it.